Quote from: bit4bit2 on December 21, 2014, 04:09:25 AM

infernoman -

You'll probably need to be more specific - although I'm no expert.

On your status page:
are your core temps < 100 on average ?
are all the pumps running roughly 3000 rpm?
are all the fans running 3500-4500 rpm?

looking through the front grill do you see the 'knight rider" lights - sequenced yellow lights?
are any red?

if its not under warranty - pop the top - which light is red?

any sign of leaks in the cooling system?

any lights looking through the side power supply screens - should be none

next onto the advanced page then the diagnostic report.....

here is the full report after re thermal pasting. one of the boards has one light that doesnt light up at all. and one that is red. in that series of led's d42 does not light and d45 is red on the board beside the power supplies.
http://pastebin.com/PnuYUhLz

currently the power stepping is at 7. any higher and both the board throttles back down to this freq. same as before. when i took the cooler off. they were so coated in thermal paste it was ridiculous. the moats for the asic dies were filled in even. all i did was replace with a dab on the top of each die. like a normal CPU. so if im wrong here and the moats need to be filled to let me know. the only thing i didnt do was take off the copper block from the pump. since i noticed a few people have done that with better results.

Also i noticed on the boards there are 2, 2 pin connectors. labeled jp1 and jp2. the board furthest away from the power supply has a connector on jp1 connecting the 2 pins together. but the rest of the boards do not

EDIT: ive tried every firmware possible. now the board with the previous red light. lights all of the leds up clicks and shuts down. the board that is working. has a red light on all firmwares below 0.76. so now i've got half a miner. that i cant fully power step