Quote from: dogie on December 23, 2014, 06:55:18 PM

Quote from: jjiimm_64 on December 23, 2014, 04:39:25 PM

Quote from: vabchgent on December 23, 2014, 04:29:12 PM

Quote from: smilingloki on December 23, 2014, 03:59:07 PM

Quote from: vabchgent on December 23, 2014, 03:06:30 PM

I have 4 x S3 antminers . I had the 10/24 firmware on them seems like MY GHS was dropping from 450 to 340+ but never going back up to 450 or even close any ideas. When I reboot the GHS jumps back up for about 10-12HRs then back down again. All set at s3+ default 225. I changed the voltage to 0770. I just installed Doges firmware on one of them to try it. Any one has any ideas it would be greatly appreciated. Thanks in advance.

do what i did, go to "scheduled tasks" and input this

0 */4 * * * /sbin/reboot

this reboots ur miners every 4 hours or u can select whatever amount to put in, i found they lasted 4 hours and then required a kick in the ass to get the ghs back up there.

I am not really good at linux. Can you please provide instructions on how to do this. After I get to the command prompt of putty.Also is this a known problem with the S3. Thanks

A reboot wont fix this when the S3 drops a blade, I have to shut down psu for a few seconds and power back up again.

I hope bitmain fixes the dropping of the blades issue. I have about 2 or 3 drop every day (out of 106)

Which firmware are you dropping blades on?

I think all mine are on 10.24.....

edit: Firmware Version Fri Oct 24 19:46:59 CST 2014