Quote from: pekatete on December 23, 2014, 04:49:18 PM

Quote from: vabchgent on December 23, 2014, 04:44:09 PM

Quote from: pekatete on December 23, 2014, 04:41:22 PM

Quote from: jjiimm_64 on December 23, 2014, 04:40:13 PM

Has anyone actually verified that changing the voltage lowers the watts at the wall?

Yes it has been checked, and NO it does not lower watts at the wall. EDIT though in theory it should......

pekatete
Any ideas on this one.

I have 4 x S3 antminers . I had the 10/24 firmware on them seems like MY GHS was dropping from 450 to 340+ but never going back up to 450 or even close any ideas. When I reboot the GHS jumps back up for about 10-12HRs then back down again. All set at s3+ default 225. I changed the voltage to 0770. I just installed Doges firmware on one of them to try it. Any one has any ideas it would be greatly appreciated. Thanks in advance.

Thanks

I am neither an expert at these things nor an electrical engineer, so take my opinion on that basis.
1. How are you powering them, i.e what PSU's and are you sharing the PSU's between rigs?
2. Are you connecting the PSU's to the same socket / extension, if so, try to separate them.

pekatete

1. How are you powering them, i.e what PSU's and are you sharing the PSU's between rigs? I have no sharing of power supplies psu 750 w Corsair
2. Are you connecting the PSU's to the same socket / extension, if so, try to separate them. I have 2 set ups on different breakers.

Also voltage setting at 225 should equal 0770 . Just making sure

Thanks