Quote from: nitrox1 on December 23, 2014, 07:48:44 PM

Quote from: vabchgent on December 23, 2014, 07:38:59 PM

Quote from: jjiimm_64 on December 23, 2014, 07:30:13 PM

Quote from: vabchgent on December 23, 2014, 07:27:37 PM

Quote from: vabchgent on December 23, 2014, 03:06:30 PM

I have 4 x S3 antminers . I had the 10/24 firmware on them seems like MY GHS was dropping from 450 to 340+ but never going back up to 450 or even close any ideas. When I reboot the GHS jumps back up for about 10-12HRs then back down again. All set at s3+ default 225. I changed the voltage to 0770. I just installed Doges firmware on one of them to try it. Any one has any ideas it would be greatly appreciated. Thanks in advance.

I know I am quoting myself but it looks like 0720 is normal voltage for 10/24 firmware running 225 Freq and 0725 for Dogies 12/19 Firmware at 225 Freq looks right. I will have to let them run for 24hrs and see what happens. Might have to go with the 12/19 firmware if everything keeps running okay because it looks like the 12/19 is running better then the 10/24 . Ill keep everyone posted. Thanks

My question would be, if the wattage is not changing at the wall, is it doing anything at all???

edit: referencing the voltage.. changing the freq definitely changes the watts at the wall

I just had to edit my post looks like 0720 is right for 225 freq but have to monitor for 24hrs make sure theres no unexplained drops

Seems low to me, but I'm going to try it, myself

Seems low to me too from what I have been reading but right now my GHS is consistent above 432GHS.