Quote from: chipless on May 10, 2019, 06:43:18 PM

Quote from: efudd on May 10, 2019, 06:13:35 PM

Quote from: Roguepanther on May 10, 2019, 05:13:38 PM

Quote from: chipless on May 10, 2019, 05:33:01 AM

Version 1.1 is now released with some improvements. The speed was increased a little and the main image was updated to Bitmains 4/23/2019 version which corrected some issues, please leave me your feedback. The link on the first post has been updated. Please read all updated info on the first post there is important information regarding future releases.

Hey Chipless, are you only using one power supply for the boards? I just updated to your latest firmware and the Z11 shuts down momentarily and then starts back up but doesnt hash, just stays at 0.

cheers mate.

That's likely a sign of too much voltage which leads too too much draw which leads to a PSU reset. What PSU are you running? APW3 or APW7 (or something else)?

You can test by pulling power and connector to one board and see if it works.... otherwise, the no hashing is also could be a sign of voltage+frequency being too high leaving the ASICs in a "limp" mode. Although, to be fair, I normally still see a 10kSol/ASIC hash in what I call "limp mode".

-j

I figured as much....I use a APW7 @220 so I am going to have to adjust for 110v users where the ps only puts out about 1200 watts compared to the full 1800 @220

I will redo the image and fix that this evening.

Im running an apw7 on 220v as well. Okay, i think the frequency/voltage is to high for my z11, if i let it sit at zero all hashboards show an X, until i reboot. Your Beta3 works fantastic though! 150ksol/s no problem, other than the share glitch. Thanks for all your hard work mate.

Roguepanther

Posts

Merits