Quote from: YSH on August 02, 2014, 09:31:00 PM

Quote from: MobileWill on August 02, 2014, 09:28:58 PM

Quote from: YSH on August 02, 2014, 09:25:45 PM

Quote from: MobileWill on August 02, 2014, 09:14:27 PM

Quote from: YSH on August 02, 2014, 08:25:43 PM

Hey Guys

Hope someone can help me!

Today I reapplied TIM, before i ran it on 336 now i can run it on 341 <10% HW errors.

I wanted to hook up a 3 pin molex 12 cm fan to the front of it instead of having 1 on the top.
But the fan won't spin up, why is that?

Is it a 12V fan connected to 12V or 5V?

Its either bad connection, sometimes molex doesn't make a good connection, or voltage to low. Could be bad fan if its used.

Unplug it and make sure none of the pins are pushed in.
Thanks, I tried to use a Corsair AF 120mm 12v. So no way to get this to work without soldering etc? Sorry I am a total newb.

So the fan already had a molex on the end? It should work. What happens when you wiggle it?

Btw soldering is a great skill to learn and not that hard. check out https://learn.adafruit.com/collins-lab-soldering

Yes, it already has a 3 pin molex on the end. Nothing happens when I wiggle it Sad

MobileWill

Posts

Merits