Quote from: aarons6 on July 16, 2015, 08:43:52 AM

Quote from: HolgerDansk on July 16, 2015, 07:12:14 AM

Quote from: aarons6 on July 16, 2015, 05:28:25 AM

Quote from: dog1965 on July 16, 2015, 12:58:25 AM

I had both fans wired directly to the PSU "both S5 original fans" then I remove the internet connection and I was still able to view my miner status page. The temp shot up well above 80c

the bold part there says you are lying...

anyway, your posts are becoming very annoying..

Annoying or not.. I had the same experience he described.

I lost my internet connection when I was out one day. Came home, heard the miners beeping. I physically looked at the miners and the heat coming off of them was tremendous. I logged in and I was able to see a temp of 102 or 106 (I can't recall right now). I freaked out, killed the power and stuck a box fan on them to cool off. So I didn't get a screenshot that time.

I don't know what the software should or should not allow (allowing access or not). I do know I got this screenshot when a pool failed (and the software did not appropriately rollover). The software also didn't shutdown. I know the fan was barely spinning (no matter what the screenshot showed). So I know there are multiple inconsistencies with what the software should do but doesn't. The screenshot temp was in harmony with my IF thermometer reading.

on the official firmware when you lose connection to a pool, cgminer doesnt run the bitmain sensors api and the ui freezes on whatever readings it was on the last time it was ran. it just loops trying to connect to pool.

but in your case the fan did slow down, as well as mine.
but dog1965 is saying his fans are on the psu via molex adapter running at 100% and his s5 was still running above 80c..

It is very troublesome when S5 is used on stock settings for fan. I connect fans directly to molex on psu they are 100% RPM all the time. Tried to kill the internet temps were fine, checked with laser thermometer on boards and heatsinks as well. So anyone who wants to solve issues with burning boards just connect fan on molex and you are good to go.