Quote from: at6871 on December 29, 2016, 09:26:18 PM

Quote from: bilabonic on December 29, 2016, 12:16:02 PM

Hi All

All of a sudden my S7 has developed a problem as in pic below....It will run for 30 mins or so then it starts 'beeping' and stops mining and the temp shows 100 !!!

Anyone got any ideas ?

What board is it (i think it is the furthest from the ethernet port) ??

ALSO is it ok just to power one or two of the 3 inputs on the faulty board ??

I have tried various psu's and still get the same and each PSU powers ALL boards...as obvious.

Cheers

Hi,

Chain 1 is the 1st board on your right when you are facing the front of the miner (with Ethernet port).
It is ok to run just 1 or 2 boards. You just have to disconnect the power and data cable of the faulty board.

Cheers, so what i thought was correct then, board one is basically opposite to the PCIE supply for the control board..

What i also asked is it possible to run one or two of the inputs (out of the 3) on the faulty board ?