Quote from: bussumseheide on November 01, 2017, 09:50:00 PM

Quote from: karlostavitch on May 19, 2017, 02:14:08 PM

Do you know if there is any way to under-clock with the newer auto-tune firmware's?

People say no but when I change my browser adress on my autotune S9 from http://192.168.1.102/cgi-bin/minerConfiguration.cgi to http://192.168.1.102/cgi-bin/minerAdvanced.cgi I do get a secret page where I can change my frequency.

In case I want to underclock I would not worry too much and could try the 550 setting..

But If I would like to overclock to 675 frequency, and I don't like the heat and noise it creates, how do I change it back to the original autotune setting?

Anyone tried to overclock using this trick of the hidden advanced page , and how did it work out ? And how did you get back to the autotune mode?

Holy SCHNIKES! The secret frequency page URL is true! I just added "/cgi-bin/minerAdvanced.cgi " after my s9s IP address.

However you get a pop-up warning. Hence, my question is... what does that "It will take about 3 hours on search frequency before mining! Are you sure?" I have never seen this before.

This is my 1st brand new factory sent Antminer - on any of the half-dozen used ones I have had, I understandably never had such issues, due to others having already over/underclocked.

Hardware Version   16.8.1.3
Kernel Version   Linux 3.14.0-xilinx-gb190cb0-dirty #57 SMP PREEMPT Fri Dec 9 14:49:22 CST 2016
File System Version   Sat Apr 29 20:01:20 EDT 2017

Please advise.