Quote from: lightfoot on December 09, 2017, 02:56:21 AM

Quote from: tommy1033 on December 09, 2017, 01:20:29 AM

Hello , do any know if there is an easy fix for cubes that makes the titans just restart ? got 2 of those "funny" cubes
also got some strange cubes showing low current on some dies and some cubes with completly dead dies is there a easy fix for this ?
i was stupid enough to buy 12 titans and payed way to much for them :/

Depends. If you have an ohm meter can you check resistance between pins 4, 6, and 8 to ground (pin 10). If pin 6 is low (under 100 ohms) the cube is bad. If pin 8 is low I can fix that, likewise if pin 4 is low.

Remember: Don't run them too hard to burn the plugs and always power down before removing any ribbon cable anywhere. And with litecoin going up in value you never know.....

ill take a look on that tomorrow , how much do you take for each board repair ?
looks like they are dead only getting about 230 ohm resistance between 4 and 10.