Quote from: Buddy_hell on May 21, 2018, 05:07:25 PM

Quote from: pyroandy on May 20, 2018, 11:59:29 AM

Quote from: Buddy_hell on May 18, 2018, 08:56:09 PM

Both.

I set up using a keyboard and mouse, then run the pi's and connect remote via VNC.

I have 9 ML2's ssplit over 3 RPIs and they exhibit similar levels of instability on v34 irrespective of USB hub, frequency or voltage settings. So hopeful for new version if i can get it running, but i get the missing bfgminer error.

andy

Missing bfgminer is normally caused by communication problems with hubs. What hubs are you using? Have you updated your pi? Can you try 1 ML2 in one hub hooked up to the pi? Do you have a PC you can try the hub on? We are assuming you downloaded the library's needed, libjansson-dev and libcurl4-openssl-dev?

Tried it on two different RPI. executed update and upgrade commands prior to install. Running two different hubs - Orico 9 port runing 3 MLD 2s and an anker 7 port running 3 MLD 2s. Both have the same error.

i have the libjannson and libcurl libraries need to check on the others. I might try refresshing and the autoremove command to see if i have some orphaned routines causing issues.

Both hubs run fine under v34- especially if i use a modest difficulty etc. If i use a low difficulty coin they tend to fallover every hour.

May I suggest a clean install of Raspbian, update it and then restart. Download the Libraries and restart again. Then install bfgminer.
Try one ML2 in one hub and work up from there. The Orico 9 port hub may struggle to run three ML2's with only a 30-watt power supply.