Quote from: mineshop.eu on January 07, 2020, 11:47:38 AM

Quote from: tjwebb on November 19, 2019, 01:34:03 AM

New Antminer S17 Pro arrived today and plugged it in. It boots up, I can access the web UI, I set my pool, and I set it to "Low Power" mode for testing. After hitting apply, the fans spin up -- similar to the S9 -- and I'm expecting to start hashing about 30 seconds later. Instead, after about 60-70 seconds, the red "Fault" light on the machine starts blinking. Fans keep spinning, web UI still works fine, but it's not hashing. I've verified that it has an internet connection using the network diagnostics tool in the Antminer Web UI. And the pool isn't down because I have other S9s hashing on it right now.

If I put it in "sleep mode", the fault light turns off -- although it still isn't hashing. Trying to set it to Low or Normal power mode causes the blinking again about 60-70 seconds.

I captured the entire kernel log here: https://gist.github.com/tjwebb/8f75822baf28f346110ffca359790364. I don't see any obvious failures there, but any insight is appreciated.

Latest bitcoin Antminers are bad quality. Ill have same problems , kernel log shows it has initialized fine but doesnt mine and then reboots after while. It is most likely one of your hashing boards died. At least i disconected one and it was working fine after. Sick of these asic miners, installed 5 of them in my mining farm 3 of them have issues after 2 weeks.

Hi -
What issues are you facing exactlly?