Quote from: chrison999 on May 29, 2014, 05:14:09 PM

Quote from: zenMiner_Eric on May 29, 2014, 04:55:50 PM

While wireless devices are not supported in the launch release, we may be including support in a future release. In the meantime, for those of you who require wireless, you can always use an inexpensive wireless bridge device like the one found here -> http://www.amazon.com/Cisco-Linksys-WET11-Wireless-Ethernet-Bridge/dp/B000066JQU

Forgive me if I'm sounding ticked off, but learning the above plus seeing my shipment bounce all over the western US instead of coming fairly direct to me have combined to put me in a pretty foul mood atm. So....

Uhhh... that site says "2 new from $100" and, frankly, $100 isn't "inexpensive" in my books. As well, if I want to go that route I now have to order another part and wait for it to come! I sure wish I'd known about this before!

So, correct me if I'm wrong... since it appears I can't use zenminer unless I either string network cable or buy an (cough!) "inexpensive" bridge can I buy a cheap memory card, install the raspberry pi o/s and the GAW cgminer software and run the furys via wifi that way???

Thanks for your help...

Regards,

Chris

Any old wireless bridge will do the trick. There are plenty of cheap ones out there. Such as this, this or even this! Those to me are inexpensive.