Quote from: vh on April 24, 2019, 07:28:39 PM

Use a powered hub.

Could be DoA, but possible low power condition keeping it from responding.

Catch 22 on that.
The software can't set the frequency of the chip to use lower power if the chips don't have the needed power to start up.

You might have some luck if you set the potentiometer to 3 o'clock.

Use a powered hub, it's better for your miner and the PC port.

Hi thank you for your reply.
I don't have a powered hub at the moment I'll try it later.
After turning the potentiometer to 3 o'clock it now measures around 6.8kΩ is this correct?
Is it normal that the chips heat up when it's idle?
Cheers.

zxhaxdr

Posts

Merits